KHBS Module
Basic
The KHBS Module is automatically detected and configured when connected the first time.
The configuration can be changed via Control UI:
http://noreya-nexus.local/nexuscontrolui/network/khbs
The openHAB bridge is automatically added.
Label description
| Label | Led On | LED off | LED blinking |
|---|---|---|---|
| BACT | Bus online | no transfer | Bus data transfer ongoing |
| TEMP | Temperature limit reached | Temperature ok | |
| BUSV | Bus voltage ok | Bus voltage too low | |
| VCC | TPUART VCC ok | ||
| VDP | TPUART VDP ok | ||
| UTX | USB/UART sending | ||
| URX | USB/UART receiving | ||
| UVCC | USB/UART VCC ok |
How to wire it up [TODO]
How to open the firewall for Programming [TODO]
Each KHBS Module can be used as IP Tunnel for programming.
However, common programming software is only able to detect on Tunnel per host (standard port) so only the KHBS Module on port 3761 [TODO Check port] is auto discoverd.
Others must be added manually.