Ethernet Module
Configuration
The Ethernet module can be configured via Control UI:
http://noreya-nexus.local/nexuscontrolui/network/ethernet
The assigned addresses can be found under:
http://noreya-nexus.local/nexuscontrolui/network
Label description
| Label | Led On | LED off | LED blinking |
|---|---|---|---|
| FDX | Full Duplex mode | Half Duplex mode | |
| LINK | Data Link Layer connection ok | no connection (no cable connected/switch offline) | |
| ACT | connected (no data transfer) | no connection | data transfer ongoing |
| 1G/10M | 10M=10Mbit mode, 1G=1000Mbit mode | NA | |
| 1G/100M | 100M=100Mbit mode, 1G=1000Mbit mode | NA | |
| FAIL | Voltage limits exceeded (may light up during plug-in) | voltage ok | |
| 2V5 | 2.5V on | 2.5V off | |
| 3V3 | 3.3V on | 3.3V off |